If you want to upgrade the interior design of your home and preserve a friendly environment, it is recommended that you seek the assistance of a skilled blind installation service provider as soon as possible. This article will go through a few key points to remember in order to install these products as efficiently as possible. The first move is to determine whether you want the vertical blinds to be installed inside the window or hung outside the window. If you install them inside the window, they have the potential to enhance the look and feel of your home, and if you install them outside the window, they have the potential to block the sunrays as effectively as possible. It is important that you have the required clips and screws to secure these things in their proper locations.Visit Tacoma blind installation for more details.

The next move is to calculate the space’s total length from the floor to the top of the window. After you’ve completed this mission, go ahead and add a quarter inch to this method of measurement. You should mark the exact location where you want the top portion of the screw to go. Then, at least three to four inches from the end of the head rail on this wall, mount an installation bracket. Extra brackets should be installed at an equal distance around the handrail, and the screws should be tightened as far as possible.

The next move is to determine which side you want to mount their control chain as well as their traverse cord on. After that, you can hold the head rail in the centre of the mounting clips and place the front lip into a groove on the front side of these clips. Switch to the back side of the head rail and press it firmly against the back side of the clip.

Then, open these things so that the vane holders are at the same distance from each other. Turn down the chain until the opening portion of the stem faces each other, and then split the vanes so that the curves face each other as much as possible. The next step is to attach the tension pulley to the bottom of the baseboard and thread the vertical cord loop through the top of the pulley. You can pull on this type of string while dragging the tension cord until this type of pulley is tight enough.

Contact Info

Southern Custom Shutters (Tacoma)
1725 Pointe Woodworth Dr NE, Tacoma, WA 98422-3480
(253) 766-5556